Belt Conveyor Common Faults And Preventive Measures(2)
Tongxiang is a conveyor equipment manufacturers china.Today we continue to share the belt conveyor common faults and preventive measures.
4.Reducer sound abnormalities
This is caused by excessive wear and tear bearings and gears or housing loose screw loose, the treatment is to replace the bearing, adjusting the gap or replace the overall reducer overhaul.
5.Reducer warming too fast
This is due to excessive fuel consumption, poor heat dissipation, reducer is buried by the source of coal, treatment is to adjust the oil, remove the source of coal.
6.Reducer leakage
The reason is the ring is damaged, reducer cabinet with uneven surface, the counterpart bolt is not tight, the method is to replace the seal, tighten the box with the bearing surface and the bearing cap bolts.
7.Roller does not turn
The reason is the roller bearing damage, rollers on both sides of the ring into the pulverized coal, blocked does not turn, so care roller too much bending force. Treatment method is to replace the roller, lift repair, reduce the height of the drop point, or fall point to use shock roller care.
Prevent belt conveyor common fault measures
(1) In order to ensure the normal operation of the belt conveyor, in addition to daily general maintenance, but also pay attention to routine inspection, regular maintenance, improve the quality of repair and maintenance.
(2) To improve the professional knowledge of maintenance personnel, the correct operation of the belt conveyor, to ensure the conveyor stably operation.
We supply conveyor accessories products,such as bearing seat,conveyor roller,etc..If you need,please contact us.
4.Reducer sound abnormalities
This is caused by excessive wear and tear bearings and gears or housing loose screw loose, the treatment is to replace the bearing, adjusting the gap or replace the overall reducer overhaul.
5.Reducer warming too fast
This is due to excessive fuel consumption, poor heat dissipation, reducer is buried by the source of coal, treatment is to adjust the oil, remove the source of coal.
6.Reducer leakage
The reason is the ring is damaged, reducer cabinet with uneven surface, the counterpart bolt is not tight, the method is to replace the seal, tighten the box with the bearing surface and the bearing cap bolts.
7.Roller does not turn
The reason is the roller bearing damage, rollers on both sides of the ring into the pulverized coal, blocked does not turn, so care roller too much bending force. Treatment method is to replace the roller, lift repair, reduce the height of the drop point, or fall point to use shock roller care.
Prevent belt conveyor common fault measures
(1) In order to ensure the normal operation of the belt conveyor, in addition to daily general maintenance, but also pay attention to routine inspection, regular maintenance, improve the quality of repair and maintenance.
(2) To improve the professional knowledge of maintenance personnel, the correct operation of the belt conveyor, to ensure the conveyor stably operation.
We supply conveyor accessories products,such as bearing seat,conveyor roller,etc..If you need,please contact us.
评论
发表评论